Rechargeable Bark Collar with Sound, Vibration and Static Modes

This automatic bark collar responds the moment your dog barks, with no remote and no button-pressing on your part. A built-in sound sensor detects barking and triggers the training mode you've chosen: sound only, sound with vibration, or sound with static stimulation. An LED display shows the mode, level, and battery charge at a glance. The collar is USB rechargeable and IP67 waterproof.

How the Collar Works

Because the collar reacts to barking on its own, your dog gets the same response every time, even when you're busy in another room. You adjust two settings:

• Trigger sensitivity: How readily the collar responds to barking.
• Training level: How strong the response is.

Together, these let you start gently and increase only if your dog needs it.

Three Training Modes

• Sound: A beep only. This is the mildest option and the best place to start.
• Sound + vibration: Adds a vibration for dogs who ignore the beep.
• Sound + static: The strongest setting. Use it only if the milder modes haven't worked, and keep it at the lowest level that gets a response.

Key Features

• Automatic bark detection: A sound sensor triggers the collar with no remote needed.
• Adjustable sensitivity and level: Fine-tune how and when the collar responds.
• LED digital display: Shows the current mode, level, and battery status.
• Auto-lock: Locks after 5 seconds without input to prevent accidental changes.
• USB rechargeable: The battery comes included, with no disposable cells to replace.
• IP67 waterproof: Handles rain, wet grass, and muddy yards.
• Knitted nylon strap: Adjustable length with a quick-release buckle.

Using the Controls

Hold the power button for 2 seconds to turn the collar on. You'll hear a single beep. Hold it again for 2 seconds to turn it off, which you'll hear as a double beep.

The collar starts in locked mode, so hold the lock button for 2 seconds to unlock it. Then use the M button to switch modes and the adjust button to change the level. After 5 seconds without input, the collar locks itself again.

Fit and Probe Covers

The metal probes come pre-installed and need to touch your dog's skin to work properly. Silicone probe covers are included in two lengths. Use the short covers for short coats and the long covers for thicker fur. On very long coats, trim the fur around the contact area so the probes can reach the skin.

Tighten the strap so the probes stay in contact without pressing hard. You should be able to slide one finger underneath. See our guide on how tight a dog collar should be for more fitting tips.

Using a Bark Collar Responsibly

A bark collar interrupts barking, but it doesn't address the cause. If your dog barks from fear, anxiety, pain, or being left alone, talk to your vet or a certified trainer before using it.

Always begin in sound mode at the lowest level. Remove the collar overnight and avoid all-day wear. Check the skin under the probes daily for redness or irritation, and reposition the collar now and then so the probes don't press on the same spot.

Frequently Asked Questions

Why doesn't the bark collar respond when my dog barks?

There are three common causes. The trigger sensitivity may be too low, the probes may not be touching the skin, or the training level may be set too low. Adjust the sensitivity first, then check the strap fit.

Can other dogs or household noise trigger the collar?

It can happen, though the sensor is designed to recognize barking patterns. If you notice false triggers from other dogs or loud sounds, lower the sensitivity setting until the collar responds only to your dog.

Can I use this collar without the static mode?

Yes. Static only activates when you select the sound + static mode. Many owners use sound or sound + vibration exclusively and never switch to static at all.

Set up the mode and level that fit your dog, and bring more calm back to your home. Browse more options in our dog training collars collection.